User's Manual
Table Of Contents
- Important Safety Instructions
- Getting Started
- Receiver
- Receiver Menus
- Locating Basics
- Advanced Locating
- Transmitter
- Appendix A: System Specifications
- Appendix B: Receiver Screen Symbols
- Appendix C: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix D: Calculating Depth Based on Distance Between FLP and RLP
- Appendix E: Reference Tables
DIGITALCONTROLINCORPORATED
DigiTrak Falcon F5
®
Operator's Manual 11
Audible Tones
The Falcon F5 receiver beeps to signal power on/off, confirm menu
changes, and acknowledge the pass/fail status of actions. The receiver
also beeps with transmitter temperature increases.
Transmitter Temperature
Warning Tones
Page 62
Two long beeps indicate a problem with the menu option selected and a failure screen will appear until you
click the trigger or remove the battery (in the case of a critical failure). Verify your setup and try the operation
again or contact DCI Customer Service for assistance.
Startup Screen
Insert a charged battery pack. To power on the receiver, click the trigger. After you have read the warning
screen, click again to acknowledge you have read and understand this manual. The receiver displays the
startup screen:
1. Receiver ID number
2. Software version
3. Customer service phone
numbers
4. Regional designation number
must match that of
transmitter
Receiver Startup Screen
Click to exit the startup screen and open the Main menu.
Receiver Menus
Page 13
If an item of the self-test fails, a warning displays and a failure message appears in place of
the system name. Please contact DCI Customer Service.
Can I change the screen brightness?
No. The display is pre-tuned for optimal contrast and visibility in all conditions.