User's Manual

Receiver
28 DigiTrak
®
F2™ Operator’s Manual
To change the pitch units setting, click the trigger to toggle between the two options. Hold the trigger in
when the arrow is next to the desired option. A checkmark will appear in place of the arrow, and you will
hear the confirmation signal.
Target Steering Menu
The Target Steering function allows you to place the F2 receiver in front of the drill head to use as a
steering target. See The Target Steering Function section for detailed information on determining where
to place the receiver and how to steer to it. This section gives instructions for using the Target Steering
menu once a target depth number has been determined. add note: re: seeing # when the target depth is
set
The first screen of the Target Steering menu turns on Target Steering to the target depth displayed: either
the default value (2 ft, 24 in., or 1 m) or the value that was most recently set. The second screen turns off
the Target Steering function and returns you to the standard locate mode screen. The third screen allows
you to program the target depth.
NOTE: The HAG setting is automatically turned off during Target Steering. If you need to adjust the
receiver to a height other than the ground level with the drill rig, then you must add that
distance to the target depth.
Turn On Target Steering
The turn on Target Steering screen displays the current target depth.
Turn On Target Steering Screen
Hold the trigger in to turn on the Target Steering function and set the target depth to the displayed value.
A checkmark will appear next to the receiver icon and you will hear the confirmation signal.
Click the trigger to advance to the turn off Target Steering screen.
Target changes in
appearance when
in Target Steering
mode.