User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Receiver
26 DigiTrak
®
F2
®
Operator’s Manual
Units & Roll Offset Menu
The units and roll offset menu allows you to change the depth and pitch units and to set a roll offset,
which is needed when the transmitter’s roll position must be compensated to match the drill head’s roll
position. When this menu option is selected, the following screen will appear with the depth units option
highlighted, as shown below.
Receiver Units & Roll Offset Menu
Click the trigger to toggle between the depth unit and pitch unit options. Hold the trigger in when the
desired option is highlighted.
Depth Units Menu
The depth units menu displays four options: IN” represents the use of inches only; FT’IN” represents the
use of both feet and inches; M.CM represents the use of metric units (meters and centimeters); and FT’
represents the use of feet only. An arrow points to the current setting, which is feet and inches in the
example shown below.
Depth Units Menu
Depth Units Menu
(Shown Highlighted)
Pitch Units Menu
Roll Offset Menu