User's Manual

Receiver
DigiTrak
®
F2
®
Operator’s Manual 15
Turning Off the Receiver
To turn off the unit, you must first access the main menu (see “Main Menu” below). Click the trigger until
you highlight the power icon
in the main menu, then hold the trigger in for at least 1 full second. You
will hear four long tones as the unit turns off.
Automatic Shutdown
The F2 receiver will shut down if no trigger action and no transmitter signal are detected for 15 minutes.
Trigger Switch
The F2 receiver operates with a single trigger switch. The trigger switch is used to turn on the unit, adjust
the screen contrast, access and select menu options, as well as to change the screen view for depth
measurements. Clicking the trigger versus holding the trigger will result in different actions.
Click – Quickly pulling and releasing the trigger (in less than 1 second). From the locate mode screen, a
single click accesses the main menu, and then each subsequent click advances through the menu
options.
Hold – Holding the trigger in for more than 1 second. This action adjusts the screen contrast, selects a
menu option, or changes the display view for depth readings.
If the receiver does not sense any trigger action within a few seconds of entering a menu, then the display
returns to the locate mode screen.
Audible Tones
The F2 receiver gives audible tones to signal power on/off, menu changes, and the pass/fail status of
actions, as summarized below. The receiver also emits tones with transmitter temperature increases (see
“Transmitter Temperature Warning Tones” in the Transmitter section).
Power On – One short beep followed by a long beep.
Power Off – Four long beeps.
Confirmation Signal – Four short beeps to confirm menu selection has been successfully executed.
Failure Signal – Two long beeps to indicate a problem with the menu item selected. A failure screen will
appear. The failure screen will display until the trigger is clicked.