User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Receiver
14 DigiTrak
®
F2
®
Operator’s Manual
Receiver Startup Screen
From the startup screen, click the trigger to continue to the locate mode screen. When there is not a
powered-up transmitter in the area, the screen will appear as shown below. The signal search symbol will
display as the receiver searches for the transmitter's signal.
Receiver Locate Mode Screen (No Transmitter)
When a transmitter is in range, the locate mode screen provides real-time data about the transmitter’s
location, temperature, pitch, roll, and signal strength. The standard receiver display screens are
discussed further under "Display Screens" later in this section. See the Locating section for detailed
instructions on locating with the F2 system.
The locate mode screen is the default receiver screen. If the receiver does not sense any trigger action
for a period of time, then the display returns to the locate mode screen.
Regional Designation
Number
(Must Match that on
Transmitter)
Model Name
Serial Number
Software Version
DCI’s Web Address
Customer Service
Phone Numbers
Signal Strength Will
Vary with Background
Interference Signal
Signal Search
Symbol