User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Receiver
12 DigiTrak
®
F2
®
Operator’s Manual
Power On/Off
Installing and Removing the Battery Pack
Insert a fully charged DCI lithium-ion battery pack so that it is flush with the back of the receiver and the
tab is securely latched, as shown below. If necessary, push on the battery pack to latch the tab in place.
Inserting Battery Pack Battery Pack Fully Inserted Removing Battery Pack
To remove the battery pack, push down on the battery tab and pull it away from the unit until the tab is
released. Then grasp the battery firmly and lift it out of the battery compartment.
Check the charge on the battery pack by pushing the battery status button
on the battery pack; the
LEDs will illuminate to indicate the amount of charge on the battery. See the Battery Charger section for
more information on checking, removing, and recharging a battery.
Turning On the Receiver
To turn on the F2 receiver once the battery is properly installed, pull and hold in the trigger for 1 second,
and then release it. You will hear a short beep followed by a long beep. The first screen you will see is the
warning screen, which will appear every time you turn on the unit.
Tab
Battery
Status Button