User's Manual

Locating
DigiTrak
®
F5 User Guide 50
NOTE: If the locate line does not appear, move the
receiver in a forward/aft direction over where you
think the transmitter is located. You will see the
locating target jump from the bottom of the screen
to the top (or vice versa). Then hold the trigger in;
this should re-reference the receiver to the
transmitter's signal and bring up the locate line.
3. Holding the receiver level, align it so that the LL is in the
box and the tick mark on the front of the receiver aligns
with the line connecting the FLP and RLP. You are now
directly over the transmitter.
Receiver Locate Mode Screen (At LL)
4. Mark the location of the locate line side to side directly
below the center of the receiver’s display.
5. Mark the left/right position of the transmitter by aligning
the FLP and RLP. This is the transmitter’s heading.
6. Hold the trigger in at this location to take a depth reading.
The depth screens will appear on the receiver and
remote display.
Locate Line
(Black When
Properly
Aligned in Box
for Depth
Reading)