User's Manual

Navigating Menus
DigiTrak
®
F5 User Guide 22
1 – Locate Mode (Shown Highlighted for selection. Opens the
locating screen. See the “Standard Display Screens” section.)
2 – Power Off (Powers off the receiver.)
3 – Calibration Menu (Opens the Calibration menu. See
“Calibration Menus” later in this section.)
4 – Height Above Ground (HAG) Menu (Opens Height Above
Ground Menu (HAG) for setting the height the receiver will be
held above ground during depth readings. See HAG Menu
later in this section.)
5 – Settings Menu (Opens the settings menu where you can
set the depth units, pitch units, time and calendar, telemetry
channel, and roll offset. See “Settings Menu” later in this
section.)
6 – Transmitter Selection Menu (Opens the Frequency
Selection menu where you can select the frequency and type
of transmitter you are using.) MORE INFO?
7 – DataLog Menu (Shown highlighted for selection. Opens
the DataLog Menu, see the “DigiTrak F5 DataLog Manual” for
more information.)
8 – Pre-Drill Checklist (Opens the Pre-Drill Checklist menu
where you can verify the receiver’s internal level is
functioning properly and perform the self-test for diagnostic
purposes. Contact the Digital Control Customer Service
department if you have questions about using this menu
item.)
9 – System Info (Opens the system info screen where you
can see the software versions and configuration of the unit.)