User's Manual

Getting Started
19 DigiTrak
®
F5 User Guide
Antenna Installation
The battery pack/brace insert is secure when the tab is
latched and a slight pull on it does not dislodge the battery.
DC Power Cable
To install the DC power cable, remove the protective cap
from the DC power port on the back of the FSD remote. The
DC power port is keyed to mate with the DC power cable.
Push the keyed end of the DC power cable into the DC power
port and rotate it clockwise to secure the cable in place.
Install the other end of the DC power cable into the DC power
source.
Installing Antenna
The antenna must be installed onto the remote display prior
to drilling in order to receive telemetry data. To install the
antenna, align its connector with the antenna port on the FSD
remote, push in and rotate the antenna connector clockwise
until it locks into place. See the figure above.
DC Port
Protective
Cap
Battery or
Brace Insert
Tab
Serial
Number
Label
Antenna
Port
Antenna
Connector