User's Manual

Getting Started
DigiTrak
®
F5 User Guide 14
Trigger Switch – Used to turn on the unit, adjust the screen
contrast, select menu options, and to change the screen view
for depth readings. See the Navigating Menus and Locating
sections for more information.
Adjusting Screen Contrast
Hold the trigger in with the receiver
held vertical. Release the trigger
when the screen contrast is adjusted.
Audible Tones
The F5 receiver gives audible tones to signal power on/off,
menu changes, and the pass/fail status of actions, as
summarized below. The receiver also emits tones with
transmitter temperature increases as defined in the
transmitter discussion later in this section.
Power On – One short beep followed by a long beep.
Power Off – Four long beeps.
Confirmation Signal – Four short beeps to confirm menu
selection has been successfully executed.
Failure Signal – Two long beeps to indicate a problem with
the menu item selected. A failure screen will appear and
display until the trigger is clicked.
NEED
NEW
PICTURE