User's Manual

Getting Started
DigiTrak
®
F5 User Guide 10
adapter and then plug the cord into an AC power receptacle
(wall outlet). If using the DC power cord, plug it directly into
the DC power source. Once powered, the orange LED (D) on
the battery charger will begin to flash.
To begin charging, install the battery pack in the orientation
shown below.
The battery pack is
properly installed
when the red LED (E)
on the battery charger
illuminates indicating
active charging. The
battery is done
charging when the
green LED (C)
illuminates. Press the
battery status button
on the battery pack to
check the charge.
Removing Battery Pack or Brace Insert
To remove the battery
pack or brace insert from
the FSD remote, F5
receiver, or F-Series
Battery Charger, push the
tab towards the face of the
battery pack/brace insert
and pull it away from the
unit as shown in the figure
“Removing Battery Pack or
Brace Insert”. When the
battery pack/brace insert is
released, grasp it firmly to
lift it out of the unit.
Push to Secure
DCI F Series Battery Charger
with F Series Battery Pack
Removing Battery Pack
or Brace Insert