User's Manual

DIGITAL CONTROL INCORPORATED
9 DigiTrak
®
F5 User Guide
A – Power Port
B – Plug from system item (2) or (5)
C – Green LED
D – Orange LED
E – Red LED
Inserting Plug into Power Port
Getting Started
Battery Pack and Charger
Checking Battery Status
Charging a Battery Pack
Only use F Series battery packs with the F Series battery
charger. Power must be supplied to the battery charger, as
indicated by the flashing
orange LED (D) on the
battery charger, before
charging a battery.
To supply power to the
battery charger, install
either the AC Adapter
(2) or DC Power Cord
(5) by inserting the
appropriate plug (B) into
the battery charger
power port (A).
If using AC power,
connect the AC power
cord (1) to the AC
LEDs
Indicate
Charge
Level
(Shown
Full)
Battery
Status
Button
(Press)
F Series Battery Pack (FBP)
Press the battery status
button. Each of the 5 LEDs
represents 20% of the
battery charge. The battery
charge status can be
checked even if it is installed
in a unit. A fully charged
FBP will power an F5
receiver for approximately
10 hours or an FSD remote
for approximately 14 hours
before recharging is
necessary.
A
B
C
D
E