User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
DigiTrak
®
F2™ Operator’s Manual 63
Maximum Bore Depth
CAPTION
Make note of the signal strength and verify that roll and pitch are displayed and that the depth reading
on the receiver is accurate. Verify depth readings at several locations along the intended bore path
with a tape measure. If necessary, recalibrate in an area where the background noise is lower than
100 points.
3. Follow all other pre-drill procedures required by the job and industry standards for a safe and effective
HDD process.