User's Manual

Remote Display
DigiTrak
®
F2™ Operator’s Manual 47
Settings Menu
The settings menu, shown below, will appear after selecting the settings menu at the main menu screen.
FSD Settings Menu Screen
The table below shows the menu options as they appear on the display with descriptions of their uses.
Any changes that are made to the settings will be saved when the FSD unit is turned off. DCI
recommends that you program the FSD settings to match the settings on your receiver.
FSD Settings Menu Options
Telemetry Channel – Opens the telemetry channel selection screen. There are four
channel options. Select the telemetry channel that matches that set on the receiver.
The remote and the receiver must be set to the same telemetry channel.
Receiver Model – Opens the receiver options screen to identify the receiver model.
The options are F2, Eclipse, LT2, and Mark 3/5. If a receiver other than the F2 is to
be used, see the MFD/FSD Operator’s Manual.
Telemetry Frequency Designation – Allows you to view the remote's telemetry
designations to ensure that the receiver is compatible. If the receiver’s frequency
designation is not listed, then it is not compatible (see “General Description” in
Receiver section).
Depth Units – Allows you to select distance units as either English or metric. When
English units are selected, the temperature will display in degrees Fahrenheit (°F).
When metric units are selected, the temperature will display in degrees Celsius (°C).
Pitch Units – Allows you to select pitch angle units. The options are percent (%) or
degree (°).
Exit – Exits the settings menu and returns to the main menu screen. After a setting
is changed, the exit option is automatically highlighted for selection.
Telemetry Channel
(Shown Highlighted)
Depth Units
Receiver Model
Exit
Telemetry Frequency
Designation
Function of
Selected Option
Pitch Units