User's Manual

Remote Display
DigiTrak
®
F2™ Operator’s Manual 43
Power On/Off
Once you have provided power to the FSD remote, either using the battery pack or a DC power source,
then you can operate the unit. The power on and off functions are as follows.
Power On – Press the execute button
for a half-second or more to turn on the FSD unit. You will
hear a tone and the main display screen will appear. If you do not hear a tone, there may be a problem
with the internal speaker; please call DCI for customer support.
Power Off –To turn off the FSD remote, you must access the main menu and select the power off option.
See the instructions for using the main menu under later in this section.
Keypad
The keypad to the right of the display window is used to operate the FSD remote.
Execute Button – The execute button (curved arrow) turns on the FSD unit and selects a
highlighted menu option. It is also used for adjusting contrast and for executing menu options. It
functions like the trigger switch on the receiver.
Direction Buttons – The up/down, left/right arrow buttons are used to navigate through
menu options. The down button also can be used to access the main menu from the remote
mode (see “Main Menu” later in this section).
Audible Tones
The FSD remote has an internal speaker that emits a tone at startup and emits warning tones when the
transmitter temperature increases. See “Transmitter Temperature Warning Tones” in the Transmitter
section for a complete listing of the warning tones and what they signify.
Adjusting Screen Contrast
The screen contrast can be adjusted from the main display screen by holding in the execute button on the
keypad and pressing the left or right arrow button for the desired adjustment: left for darker, right for
lighter. You can also adjust the screen contrast by using the contrast adjustment option in the main menu
(see "Main Menu" later in this section).