User's Manual

Receiver
DigiTrak
®
F2™ Operator’s Manual 31
To change the in./cm setting, click the trigger to move the underline to the in/cm position, and then hold
the trigger in until a box surrounds the number. Once you see the box, click the trigger to increase in 1-in.
or 2-cm increments. Once you have the desired in./cm setting, hold in the trigger.
NOTE: If you click past 11 in. or 98 cm, then the number in the ft/m setting will automatically increase.
To set this value as your target depth, click the trigger to move the underline underneath the checkmark
and hold the trigger in. A confirmation tone will sound.
For information about how to position the receiver ahead of the tool for target steering, see the Target
Steering Function section.
Display Screens
The basic receiver displays include the locate mode screen, the depth mode screen, and the predicted
depth screen. These are presented below. For more information regarding these screens and for detailed
locating instructions, please see the Locating section.
Locate Mode Screen
When a transmitter is in range, the locate mode screen provides real-time data about the transmitter’s
location, temperature, pitch, roll, and signal strength. The roll/pitch meter shows the quality of the signal
from the transmitter. The locate mode screen is the default screen setting.
Receiver Locate Mode Screen with Transmitter in Range (Trigger Out)
((Should we put info here re: the roll/pitch update meter like we did for the Remote Display?))
2
Locating target
(FLP or RLP)
Transmitter Signal
Strength
Roll/Pitch
Update Meter
Roll Indicator
Transmitter
Temperature
Transmitter Pitch
Receiver