User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
30 DigiTrak
®
F2™ Operator’s Manual
Hold the trigger in to advance to the screen shown below where you can set the target depth value. At
this screen, you can click through the available fields, which are the foot or meter (ft/m) setting, the inches
or centimeters (in./cm) setting, and the checkmark (used to confirm the target depth setting).
Set Target Depth Value Screen (Foot or Meter Setting Highlighted)
In this example, the line under the number 2 indicates that the ft/m setting is highlighted. To change this
setting, hold in the trigger until a box appears around the number 2, as shown below. Once you see the
box, click the trigger to increase (in 1-ft or 1-m increments) to the desired number. Once you reach the
desired number, hold in the trigger, and the box will turn back into an underline under the ft/m setting.
Set Target Depth Value Screen (Foot or Meter Setting Selected)
NOTE: The F2 receiver’s ft/m setting can be programmed to a maximum of 99 ft or 30 m. If your
previous target depth is greater than your new target depth, you must click past 99 ft or 30 m
to cycle back to the initial settings of 2 ft or 0.5 m.
Underline indicates
value is highlighted
and can be changed.
Checkmark is used
to confirm the target
depth setting.
Foot or
Meter Setting
Inches or
Centimeters Setting