User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
DigiTrak
®
F2™ Operator’s Manual 13
Receiver Warning Screen
Next, click the trigger to check the box on the warning screen acknowledging that you have read and
understand this manual. You must read this entire manual before using the F2 system for any directional
drilling procedure.
The self-test will automatically initiate after the checkmark is displayed in the box. The self-test is
performed every time the receiver is powered on. The following screen will display indicating a successful
self-test. If a component of the self-test fails, contact DCI Customer Service before proceeding.
Receiver Self-Test Pass Screen
The startup screen will automatically appear after the self-test. The startup screen displays the informa-
tion shown below. Note the regional designation number shown inside the globe icon (
); this number
must match that shown on the transmitter (see photo of FX transmitter in Transmitter section).