User's Manual

DIGITAL CONTROL INCORPORATED
22 DigiTrak F5 Operator’s Manual
Finding the Locate Line (LL)
7. Continue to walk in the direction of the drill or the last known transmitter location. Keep
the locating target on the vertical crosshair and observe that the signal strength is
increasing.
Receiver Locate Mode Screen
(FLP Behind Receiver, Which Is Moving Toward LL)
If the signal strength decreases, you may actually have just located the RLP. Position
yourself further away from and facing the drill to locate the FLP.
8. When the target reaches the bottom of the screen, the locate line appears and the
target turns solid black to indicate your focus should now be on the LL.
If the locate line does not appear and the ball flips to the top of the screen, move the
receiver in a forward/backward direction over where the ball flips, then hold in the
trigger to re-reference the receiver to the transmitter’s signal and bring up the locate
line.
Signal strength
higher than
value at FLP
Locating target
aligned with
vertical crosshair