User's Manual

DIGITAL CONTROL INCORPORATED
20 DigiTrak F5 Operator’s Manual
The FLP will be found further out in front of the drill head as the drill head gets
deeper.
3. Observe the position of the locating target ( ) relative to the receiver box on the
display. The figures below illustrate what you might see on the display and the actual
position of the receiver, transmitter, and locate points. Note that the FLP is ahead of
and to the left of the receiver, as shown in the receiver display.
Receiver Locate Mode Screen
Actual Position of Receiver
and Transmitter
4. Walk in the direction indicated by the picture on the screen to center the target in the
box, which is forward and to the left in this example.
5. When the target is centered in the box, hold the trigger in for one second so the
receiver can get a “lock” on the reference signal. The “R” symbol will appear at the
top of the depth screen. The locate line (LL) will not display later without this
reference.
Locating
“target”
“Box”