User's Manual

DIGITAL CONTROL INCORPORATED
18 DigiTrak F5 Operator’s Manual
Marking Locate Points
The locate points (FLP and RLP) and the locate line (LL) must be found and accurately
marked during the locating procedure. To mark a locate point, stand with the receiver level at
the locate point. Look down the vertical axis that runs through the center of the display to
project a plumb line to the ground (see figure below). Mark where this plumb line hits the
ground .
Plumb Line for Marking Locate Points
Plumb line or
vertical axis
Center of
display
Front of
receiver
Place marker
straight down
on ground