User's Manual

DIGITAL CONTROL INCORPORATED
xlvi DigiTrak F5 Operator’s Manual
Execute Button Use to turn on the FSD unit, select a highlighted
menu option, adjust contrast, and execute menu options.
Functions like the trigger switch on the receiver.
Direction Buttons Use to navigate through menu options. Use the
down button to access the main menu from the remote mode.
The direction buttons function like the toggle switch on the
receiver.
Power On
Once you have provided power to the FSD remote using either the battery pack or a DC
power source, turn it on by pressing the execute button for about two seconds. A tone will
sound and the main display screen will appear (see Remote Mode on page xlviii).
Audible Tones
The FSD remote has an internal speaker that beeps at startup and emits warning tones when
the transmitter temperature increases. See Transmitter Temperature Warning Tones on page
xlii for a complete listing of the warning tones and what they signify.
Adjusting the Viewing Angle
The FSD remote allows a viewing angle of 180° left/right, 90° up/down, and 270° about the
display’s center.
Up/Down Loosen and squeeze the two knobs on the back of the remote display, then
adjust the screen as desired and tighten the knobs. If the knobs are loose,
the display will hold its vertical position only until the knobs are squeezed
together or the display is vibrated. Thus, DCI recommends tightening the
knobs before drilling.