User's Manual

DIGITAL CONTROL INCORPORATED
DigiTrak F5 Operator’s Manual xlv
Connecting the DC Power Cable
The DC power port and DC power cable connector are keyed for proper alignment. To
connect the power cable, remove the protective cap from the power port on the back of the
remote, align the key marks in the connector with the key slots in the power port, and push in
and rotate the connector clockwise until the connector locks into place. Connect the other
end of the DC cable to a DC power source.
DC Power Cable (right) and Brace Insert Installed in FSD Remote
When powering the FSD with DC power, install the brace insert in the battery compartment.
The brace insert provides structural integrity and preserves battery power. Install and remove
it in the same manner as the battery discussed previously.
Note If both a battery pack and the DC cable are connected at the same
time, the remote will draw power from the battery until its voltage is
below the DC source voltage.
Keypad
Use the keypad to the right of the display window to operate the FSD remote.
DC power
port
Brace
insert
Protective
cap
Battery
tab
Keyed
connector