User's Manual

DIGITAL CONTROL INCORPORATED
xxxvi DigiTrak F5 Operator’s Manual
Note Do NOT use the battery contact spring at either end of a single SuperCell
™
battery.
Select the frequency of a dual-frequency transmitter by installing the batteries with
the transmitter pointing either up or down:
Load batteries
with transmitter
pointing up
To operate
F5D 12/1.3 or
F5Dp 12/1.3
transmitter in
single high (SH)
mode (12 kHz)
or
To operate
F5D 19/12 or
F5Dp 19/12
transmitter in
high-frequency
mode (19.2 kHz)
1.5 V 1.5 V
SuperCell
1.5 V 1.5 V
SuperCell
Load batteries
with transmitter
pointing down
To operate
F5D 12/1.3 or
F5Dp 12/1.3
transmitter
in dual high (DH)
mode (12 kHz) or
dual low (DL)
mode (1.3 kHz)
or
To operate
F5D 19/12 or
F5Dp 19/12
transmitter in
low-frequency
mode (12 kHz)
Setting the Frequency of Dual-Frequency Transmitters
Note The pressure sensor in an FPT (F5Dp 19/12 or F5Dp 12/1.3) will be set
to zero when the transmitter powers up.
3. After installing the batteries, replace the battery cap. Be sure to keep a dual-
frequency transmitter in the correct orientation while replacing the battery cap.
When using a “19/12” dual-frequency transmitter (F5D 19/12 or F5Dp 19/12), you can
change the frequency after batteries are installed (see Changing the Frequency of a
“19/12” Dual-Frequency Transmitter on page xli). The “12/1.3” dual-frequency
transmitters (F5D 12/1.3 and F5Dp 12/1.3) must be set to single (12 kHz) or dual
mode (12/1.3 kHz) when batteries are installed.
3.6 V