User's Manual

DIGITAL CONTROL INCORPORATED
xxxii DigiTrak F5 Operator’s Manual
Standard Receiver Screen Symbols
Receiver Battery – Depicts the remaining battery life of the receiver (shown 80% full here).
When empty, the icon will flash in the Locate Mode screen , signifying that it is critical to
change the battery immediately.
Dual Transmitter Symbol – Appears to the upper left of the transmitter roll icon when the
receiver is set for an F5 12 kHz or dual transmitter and a transmitter in dual mode is
detected. The letters “DL” or “DH” will accompany this symbol to show whether the receiver
is set to detect the dual low (1.3 kHz) or dual high (12 kHz) frequency, respectively.
Recording Symbol – Indicates that pressure-tension data is being recorded. Appears to the
lower right of the transmitter roll indicator when P-T data recording is enabled.
Pressure Symbol – When using a fluid pressure transmitter, the number next to this icon
on the Locate Mode screen indicates the pressure reading. If the pressure reaches an
overlimit condition (from 100–250 psi or 690–1760 kPa), the value will appear red. When the
pressure reaches the overload condition (over 250 psi or 1760 kPa), the value will display as
“+OL”.