User's Manual

DIGITAL CONTROL INCORPORATED
xx DigiTrak F5 Operator’s Manual
Transmitter Selection Menu
This menu allows you to specify the transmitter type, model, and frequency, when applicable.
Transmitter Selection Menu
If the selected transmitter type has more than one model option, as in the case of F5,
F Series, Cable, and FPT transmitters, another screen appears to select the specific
transmitter model. If a dual-frequency transmitter is selected, an additional screen appears to
select the desired frequency.
After a transmitter selection, the display returns to the main menu with the new transmitter
selection showing at the top of the screen. Select Exit during transmitter selection returns the
display to the previous screen with no changes. See Transmitter on page xxxiii for more
information on F5 transmitter options.
Note If you purchased a TensiTrak for monitoring and recording pullback
pressure and tension, a TensiTrak icon will appear on a second screen
for the above menu. Consult your TensiTrak owner’s manual (available
online) for additional information, as selecting TensiTrak will significantly
change the appearance of the Locate Mode display screen.
Drill DataLog Menu
This menu allows you to enable or disable the drill DataLog function to record pilot hole drill
data electronically, set up new drill jobs, view and delete drill jobs from the receiver, and
upload drill jobs via Bluetooth to a computer with LWD software installed. The menu options
span two screens:
Description of
highlighted option
Current transmitter
selection
Down arrow indicates
more options below
(toggle down)
F5 transmitters (shown
highlighted)
Exit