User's Manual

DIGITAL CONTROL INCORPORATED
xii DigiTrak F5 Operator’s Manual
Toggle and Trigger Switches
The F5 receiver has two switches for operating the system: a toggle (thumb switch) located
on the top of the unit and a trigger located under the handle.
Toggle Switch Used to access and navigate menus. Moves in four directions: left, right,
up (toward the display), and down (toward the handle).
Trigger Switch Used to turn on the receiver (hold), to select menu options, and to
change the screen view for depth readings. Click once or hold, depending on
the desired action.
Audible Tones
The F5 receiver beeps to signal power on/off, to confirm menu changes, and to acknowledge
the pass/fail status of actions, as summarized below. The receiver also beeps with transmitter
temperature increases (see Transmitter Temperature Warning Tones on page xlii ).
Power On A series of short beeps.
Power Off Four short beeps.
Confirmation Signal Four short beeps confirm menu selection has been successfully
executed.
Failure Signal Two long beeps indicate a problem with the menu option selected and a
failure screen appears until you click the trigger or remove the battery (in the
case of a critical failure). Verify your setup and try the operation again or call
DCI Customer Service for assistance.
Installing and Removing the Battery Pack
Insert a fully charged DigiTrak F Series battery pack so it is flush with the back of the receiver
and the tab is securely latched. To remove the battery pack, push down on the battery tab
and lift the battery pack from the battery compartment.
Battery Pack Fully Inserted
Removing Battery Pack
Battery tab