User's Manual
Table Of Contents
- This device complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference tha...
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
DIGITAL CONTROL INCORPORATED
DigiTrak
®
F2
®
Operator’s Manual 53
Battery Charger
General Description
F Series Battery Charger System
The DigiTrak F Series Battery Charger (FBC) system includes AC and DC power cords, an AC adapter,
and three rechargeable lithium-ion battery packs. The battery packs are used to power the F2 receiver
and the FSD remote. Only F Series battery packs should be used in the F2 system and in the battery
charger. Using another type of battery could result in system damage and voiding of the warranty.
The battery charger can operate from AC (100–240 V, 50–60 Hz, 1500 mA max.) or DC (12 V, 5000 mA
max.) power sources, and power cords are provided for both. The AC power cord that is shipped with
your system is standard to your global area of operation.
A fully charged F Series battery pack will power an F2 receiver for
approximately 12 hours or an FSD remote for approximately 14
hours before recharging is necessary. The battery pack can be
recharged approximately 400 times before the battery life is reduced
by up to 50%.
To check the charge status of the F Series battery pack at any time,
press the battery status button below the five LEDs on the battery.
Each of the LEDs represents 20% of the battery charge. While
charging, the LEDs will flash to show the current charge level. Upon
completion of the charge cycle, all five LEDs will illuminate briefly
and then turn off.
AC Adapter
AC Power
Cord
F Series
Battery Charger
F Series
Battery Packs
DC Power
Cord
F Series Battery Pack
Tab
LEDs
Indicate
Charge
Level
Battery
Status
Button