User's Manual
Table Of Contents
- This device complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference tha...
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Receiver
DigiTrak
®
F2
®
Operator’s Manual 15
Receiver Startup Screen
From the startup screen, click the trigger to continue to the locate mode screen. When the receiver is not
detecting a transmitter, the screen will appear as shown below. The signal search symbol will display as
the receiver searches for the transmitter’s signal.
Receiver Locate Mode Screen (No Transmitter)
When the receiver is detecting a transmitter, the locate mode screen provides real-time data about the
transmitter’s location, temperature, pitch, roll, and signal strength. The standard receiver display screens
are discussed further under “Display Screens” later in this section. See the Locating section for detailed
instructions on locating with the F2 system.
The locate mode screen is the default receiver screen. If the receiver does not sense any trigger action
for a period of time, then the display returns to the locate mode screen.
Regional Designation
Number
(Must Match that on
Transmitter)
Model Name
Software Version
DCI’s Web Address
Customer Service
Phone Numbers
Signal Strength Will
Vary with Background
Interference Signal
Signal Search
Symbol
Serial Number
Indicates Two-
Frequency Receiver
(12 kHz and 19 kHz)