User's Manual
Table Of Contents
- FCC Compliance Statement
- This equipment complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this equipment may not cause harmful interference, and (2) this equipment must accept any interference received, including interfer...
- Table of Contents
- Safety Precautions and Warnings
- Introduction
- Power Setup
- Cable Mode
- Appendix A: System Specifications and Maintenance Requirements
- LIMITED WARRANTY
Cable Mode
DigiTrak
®
MFCB™ Operator’s Manual 19
Roll Offset Menu (Disable or Set)
Selecting will disable roll offset and return you to the standard cable or SST mode display screen.
The value displayed for roll will be that of the transmitter. Selecting “Set” will program the roll offset to the
displayed value.
The clock moves to the upper right of the display when using an SST transmitter, Target Steering, or
receiving depth readings. The roll offset value will still display next to the clock as shown below.
SST Target Steering Display with Roll Offset
If a standard Eclipse Cable transmitter is used, the screen will display as above but without the yaw data
and the roll will display by clock position as opposed to the 360⁰ indicator shown here. The roll offset is
always displayed by degree.
“Set” programs the
displayed value as
the roll offset
Exit (highlighted)
exits the menu
with no change
“Stop” disables
the roll offset
Drill head’s 12 o’clock
Offset to transmitter’s
12 o’clock index slot