User Manual
Table Of Contents
- Operator’s Manual
- Digital
- Control
- Incorporated
- Safety Precautions and Warnings
- Introduction
- System Components
- Startup and Operating Instructions
- SST Operating Procedure
- Setting Up SST Laptop
- Setting Up Equipment and Site
- 2. Establish Borepath Reference Line and Mark Borepath
- 3. Assemble and Torque-up Non-Magnetic Housing to Non-Mag Tool
- 4. Align Drill to Marked Borepath
- 5. Position & Align Non-mag Tooling Assembly onto Marked Borepath
- 6. Stage SST Equipment and Power Sources Adjacent to Tooling Assembly
- 7. Power Up Eclipse SST Equipment
- 8. Measure SST Transmitter Current Draw
- 9. Install SST Transmitter into Aligned Non-mag Tooling Assembly
- Setting Reference Heading (Ref Yaw) and Roll Offset
- Calibrating SST Tool and Confirming Proper System Operation
- Logging Drill Run
- Summary of Basic Operating Procedure
- SST Operating Procedure
- Computer Software Instructions
- Inputting and Changing Drill Data
- APPENDIXImporting Topography, Drill Plan, and Planned Deviation from Excel File
- LIMITED WARRANTY
Changing Drill Data
Graphing Options
You can change the appearance of the Profile and Deviation plots in a variety of ways. The various
options that are available are discussed below. Some options will alter the appearance of both plots, and
some will only alter the plot in which you are working. Place your cursor in the plot area that you want to
change to open the Chart FX dialog box that affects that plot area.
Changing Appearance and Location of X and Y Axes
To change the appearance and location of the x- or y-axis in either the Profile or Deviation plot, place the
cursor in the desired plot area, and right click; then select Properties... from the popup menu to open the
Chart FX Properties dialog box. Select the Axes tab, as shown below.
Chart FX Properties Dialog Box – Axes Tab
Click on the top left field’s drop-down arrow and select the X or Y axis, then click the Details button at the
bottom of the dialog box to open the X or Y Axis Properties dialog box.
Eclipse
®
SST
®
Operator’s Manual 51