User Manual
Table Of Contents
- Operator’s Manual
- Digital
- Control
- Incorporated
- Safety Precautions and Warnings
- Introduction
- System Components
- Startup and Operating Instructions
- SST Operating Procedure
- Setting Up SST Laptop
- Setting Up Equipment and Site
- 2. Establish Borepath Reference Line and Mark Borepath
- 3. Assemble and Torque-up Non-Magnetic Housing to Non-Mag Tool
- 4. Align Drill to Marked Borepath
- 5. Position & Align Non-mag Tooling Assembly onto Marked Borepath
- 6. Stage SST Equipment and Power Sources Adjacent to Tooling Assembly
- 7. Power Up Eclipse SST Equipment
- 8. Measure SST Transmitter Current Draw
- 9. Install SST Transmitter into Aligned Non-mag Tooling Assembly
- Setting Reference Heading (Ref Yaw) and Roll Offset
- Calibrating SST Tool and Confirming Proper System Operation
- Logging Drill Run
- Summary of Basic Operating Procedure
- SST Operating Procedure
- Computer Software Instructions
- Inputting and Changing Drill Data
- APPENDIXImporting Topography, Drill Plan, and Planned Deviation from Excel File
- LIMITED WARRANTY
Operating Instructions
Eclipse
®
SST
®
Operator’s Manual 23
75
o
F
Yaw Ref:170.0
o
Yaw:230.7
o
60.7
o
90°
7.5
%
SST Remote Screen Showing Heading 60.7° to Right of Reference Heading
11. Set Roll Offset on Remote (if needed)
Using the remote display and the receiver, the SST transmitter’s 0° roll setting can electronically be
compensated if it does not match the bit’s 0° roll position. To compensate for a roll difference, the receiver
and remote display must have their Roll Offset functions set.
To set the Roll Offset on the remote display, push the right arrow (from the steering screen). The Set New
Roll Offset dialog box will display.
Set New Roll Offset
Are you sure?
Set New Roll Offset Dialog Box
Push the right arrow to Y for Yes and press the execute button. You will see the clock position on the
remote change to read 0°, and the Roll Offset value will appear at the top of the screen (240 in this
example).
Reference
Heading
Current
Transmitter
Heading