User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- General Description
- Toggle and Trigger Switches
- Audible Tones
- Installing and Removing the Battery Pack
- Power On
- Power Off
- Main Menu
- Locate Mode
- Calibration Menu
- Height-Above-Ground (HAG) Menu
- Settings Menu
- Transmitter Selection Menu
- Drill DataLog Menu
- Pressure-Tension DataLog Menu
- Using the Keypad
- Display Screens
- Standard Receiver Display Screen Symbols
- Transmitter
- Remote Display
- Battery Charger
- System Setup
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Target Steering
DigiTrak
®
F5™ Operator’s Manual 85
Target Steering Locate Mode Screen
When a fluid pressure sensing transmitter is used, the pressure data will display in a field between the
transmitter pitch and approximate depth of transmitter.
Steering to the Target
Once the target depth has been entered on the receiver and the receiver has been positioned ahead of
the tool as the target, select remote mode from the remote’s main menu (see “Main Menu” in the Remote
Display section). You will then see the Target Steering screen shown below.
Target Steering on Remote Display
Horizontal distance
between transmitter
and receiver
Approximate
transmitter depth
Transmitter roll
Transmitter pitch
Horizontal distance
between transmitter
and Receiver
Transmitter
temperature
Approximate
transmitter depth
Transmitter pitch
Locating target
(FLP)
Roll/pitch update
meter
Roll indicator
Steering indicator
Center of
crosshairs