User's Manual

System Setup
66 DigiTrak
®
F5™ Operator’s Manual
2. Ensure that the drill head is at its 12 o’clock position and that the transmitter is on. Note the roll value
showing on the screen.
3. With the set roll offset option highlighted, as shown above, click the trigger to activate roll offset. The
confirmation signal will sound as the screen returns to the settings menu with roll offset enabled.
If the receiver does not detect a roll signal from the transmitter, the roll offset operation will fail and
the following screen will display.
Roll Offset Failure Screen
Click the trigger to retry setting the roll offset or toggle right to select exit and return to the settings
menu. If the roll offset failure screen appears, verify the setup and try again or contact DCI Customer
Service.
Disable Roll Offset
To turn off the roll offset function, select the disable roll offset option from the roll offset menu. The
confirmation signal will sound as the screen returns to the settings menu. The value that displays for roll
on the locate mode screens will be that of the transmitter.