User's Manual

System Setup
DigiTrak
®
F5™ Operator’s Manual 65
Set Roll Offset
If you cannot align the 12 o’clock position of the transmitter to that of the drill head, you will need to set
and enable the roll offset function. The roll offset function electronically compensates to match the
transmitter’s 12 o’clock position to the drill head’s 12 o’clock position.
To access the roll offset function, open the receiver main menu and then select the settings menu. From
the settings menu, select the roll offset menu option.
Roll Offset Menu
Enable Roll Offset
1. Select the enable roll offset option from the roll offset menu to display the menu shown below.
Enable Roll Offset Menu
Disable roll offset
Exit (returns to
settings menu)
Enable roll offset
(shown highlighted)
Set roll offset
(shown highlighted)
Roll indicator
showing transmitter’s
uncompensated roll
position