User's Manual

Remote Display
44 DigiTrak
®
F5™ Operator’s Manual
Power Options
The FSD remote can be powered by either an F Series battery pack or DC power. A brace insert is
provided with the system for use when powering the FSD with DC power. It is the same size as the
battery pack, and it is installed and removed in the same manner as the battery pack.
Installing and Removing the Battery Pack or Brace Insert
To install, hold the battery pack or brace insert with the tab facing up and away from the FSD remote,
then insert it into the battery compartment and push it in until the tab latches in place.
To remove the battery pack or brace insert, push down on the battery tab and pull it away from the
remote until the tab is released.
Connecting the DC Power Cable
The DC power port and DC power cable connector
are keyed for proper alignment. To connect the power
cable, remove the protective cap from the power port
on the back of the remote. Then align the key marks
in the connector with the key slots in the power port.
Push in and rotate the connector clockwise until the
connector locks into place. Install the other end of the
DC cable into the DC power source.
DC Power Cable
Install the brace insert in the battery compartment. The brace insert provides structural integrity and
preserves battery power.
NOTE: If both a battery pack and the DC cable are installed, the remote will draw power from the
battery until the battery voltage is below the DC source voltage.
DC Power Cable and Brace Insert
Installed in FSD Remote
DC power
port
Brace
insert
Keyed connector
Protective
cap
Battery
tab