User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- General Description
- Toggle and Trigger Switches
- Audible Tones
- Installing and Removing the Battery Pack
- Power On
- Power Off
- Main Menu
- Locate Mode
- Calibration Menu
- Height-Above-Ground (HAG) Menu
- Settings Menu
- Transmitter Selection Menu
- Drill DataLog Menu
- Pressure-Tension DataLog Menu
- Using the Keypad
- Display Screens
- Standard Receiver Display Screen Symbols
- Transmitter
- Remote Display
- Battery Charger
- System Setup
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Receiver
30 DigiTrak
®
F5™ Operator’s Manual
Standard Receiver Display Screen Symbols (Continued)
Receiver Battery – Depicts the remaining battery life of the receiver (shown 80% full
here). When empty, the icon will appear in the locate mode screen and will flash
signifying that it is critical to change the battery immediately.
Dual Transmitter Symbol – Appears to the upper left of the transmitter roll icon when a
dual mode transmitter is detected. The letters “DL” or “DH” will accompany this symbol
to show whether the receiver is set to detect the dual low (1.3 kHz) or dual high (12 kHz)
frequency, respectively.
Recording Symbol – Indicates that pressure-tension data is being recorded. Appears
to the lower right of the transmitter roll indicator when P-T data recording is enabled.