User's Manual

Receiver
18 DigiTrak
®
F5™ Operator’s Manual
Settings Menu
The settings menu is used to set the following options on the receiver: depth units, pitch units, time and
calendar, telemetry channel, and roll offset, as shown below.
Receiver Settings Menu
Any changes made to settings will be saved when the receiver is turned off. DCI recommends that you
program the receiver settings and the remote display settings to match each other.
Depth Units Menu
The depth units menu has four options: xx" represents the use of inches only; x'xx" represents the use of
both feet and inches; x.xx m represents the use of metric units (meters and centimeters); and x.xx'
represents the use of feet only. Use the toggle switch to highlight the desired option, and click the trigger
to select it. The confirmation signal will sound as the screen returns to the settings menu with the exit
option highlighted.
NOTE: The temperature units are determined by the depth units selected. Celsius (°C) temperature
units will display if metric depth units are selected, and Fahrenheit (°F) temperature units will
display if English depth units (feet only, inches only, or feet and inches) are selected.
Pitch Units Menu
The pitch units menu has two options: degrees (x°) and percent (x%). Use the toggle switch to highlight
the desired option and click the trigger to select it. The confirmation signal will sound as the screen
returns to the settings menu with the exit option highlighted.
Depth units menu
(shown highlighted)
Exit
Pitch units menu
Roll offset menu
Telemetry channel
menu
Current setting of
highlighted option
Set time and
calendar