User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- General Description
- Toggle and Trigger Switches
- Audible Tones
- Installing and Removing the Battery Pack
- Power On
- Power Off
- Main Menu
- Locate Mode
- Calibration Menu
- Height-Above-Ground (HAG) Menu
- Settings Menu
- Transmitter Selection Menu
- Drill DataLog Menu
- Pressure-Tension DataLog Menu
- Using the Keypad
- Display Screens
- Standard Receiver Display Screen Symbols
- Transmitter
- Remote Display
- Battery Charger
- System Setup
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- LIMITED WARRANTY
Receiver
DigiTrak
®
F5™ Operator’s Manual 13
Power On
To turn on the receiver, pull in and hold the trigger switch for at least 2 seconds, then release the trigger.
A series of beeps will sound, and then a screen with the F5 logo will display while the receiver performs a
self-test. The warning screen shown below will then display.
Receiver Warning Screen
You must pull and release (click) the trigger switch to acknowledge that you have read and understand
this manual. If all items of the self-test passed, the startup screen shown below will display.
Receiver Startup Screen
Click the trigger to exit the startup screen and open the main menu (see “Main Menu” below).
NOTE: If an item of the self-test fails, the warning symbol will display and a failure message will
appear in place of the system name. Contact DCI Customer Service for support.
Regional
designation
number (must
match that of
transmitter)
System name
Receiver ID number
Software version
Web address
Customer service
phone numbers