User's Manual

System Setup
62 DigiTrak
®
F5™ Operator’s Manual
Set Roll Offset
If you cannot align the 12 o’clock position of the transmitter to that of the drill head, you will need to set
and enable the roll offset. The roll offset function electronically compensates to match the transmitter’s 12
o’clock position to the drill head’s 12 o’clock position.
To access the roll offset function, open the receiver main menu and then select the settings menu. From
the settings menu, select the roll offset menu option.
Roll Offset Menu
Enable Roll Offset
1. Select the enable roll offset option from the roll offset menu.
Enable Roll Offset Menu
2. Ensure that the drill head is at its 12 o’clock position and that the transmitter is on. Note the roll
value showing on the screen.
3. With the set roll offset option highlighted, as shown above, click the trigger to activate roll offset.
The confirmation signal will sound as the screen returns to the settings menu.
Disable Roll Offset
Exit
Enable Roll Offset
(Shown Highlighted)
Set Roll Offset
(Shown Highlighted)
Exit
Clock Face
Showing
Transmitter’s
Uncompensated
Roll Position