User's Manual

Remote Display

44 DigiTrak

F5™ Operator’s Manual

Adjusting the Viewing Angle

The FSD remote allows you to adjust the viewing angle through a range of 180° left/right, 90° up/down,

and 270° about the display’s center.

Up/Down – Loosen and squeeze the two knobs on the back of the remote display, then adjust the screen

as desired and tighten the knobs. If the knobs are loose, the display will hold its vertical position only until

the knobs are squeezed together or the display is vibrated. Thus, DCI recommends tightening the knobs

before drilling. Note: Adjusting the up/down orientation of the display without loosening the knobs can

damage the unit.

Loosen Display Knobs Adjust Viewing Angle Tighten Display Knobs

Left/Right – When the FSD remote’s magnetic

base is secure, you can adjust the left-right viewing

angle by rotating the display about the base.

Center – With the magnetic base secure, take hold

of the display and rotate it to the desired

orientation.

Attaching / Removing Visor

The removable visor on the FSD remote shields

the screen from environmental conditions such as

rain and sun. The visor is held in place by a ridge

on the top of the display and channels on the sides

of the display.

To install the visor, slide the pegs on the visor

along the peg channels on the sides of the display

until the visor locks over the ridge.

To remove the visor, push the visor back over the

ridge and along the channels.

Squeeze

Knobs

Rotating for Left/Right and Center

Viewing Adjustments

Ridge

Peg Channel

Rotation for

Left/Right Viewing

Adjustment

Rotation for Cente

Viewing Adjustment