User's Manual

Receiver

18 DigiTrak

F5™ Operator’s Manual

Receiver Settings Menu

Any changes made to settings will be saved when the receiver is turned off. DCI recommends that you

program the receiver settings and the remote display settings to match each other.

Depth Units Menu

The depth units menu has four options: xx" represents the use of inches only; x'xx" represents the use of

both feet and inches; x.xx m represents the use of metric units (meters and centimeters); and x.xx'

represents the use of feet only. Use the toggle switch to highlight the desired option, and click the trigger

to select it. The confirmation signal will sound as the screen returns to the settings menu with the exit

option highlighted.

NOTE: The temperature units are determined by the depth units selected. Celsius (°C) temperature

units will display if metric depth units are selected, and Fahrenheit (°F) temperature units will

display if English depth units (feet only, inches only, or feet and inches) are selected.

Pitch Units Menu

The pitch units menu has two options: degrees (x°) and percent (x%). Use the toggle switch to highlight

the desired option and click the trigger to select it. The confirmation signal will sound as the screen

returns to the settings menu with the exit option highlighted.

Set Time and Calendar

The set time and calendar option on the settings menu allows you to program the time and date into your

receiver. This action is necessary when you are using the DataLog function.

When you select the set time and calendar option, the following screen will display.

Depth Units Menu

(Shown Highlighted)

Exit

Pitch Units Menu

Roll Offset Menu

Telemetry Channel

Current Setting

of Highlighted

Option

Set Time and

Calendar