User's Manual

Using Software
44 Eclipse
®
TensiTrak
®
Operator’s Manual
E-mailing Project Files
You can send Eclipse TensiTrak files via e-mail. E-mailed files can be opened on any computer that has
the same version of the Eclipse TensiTrak software as used on the originating computer.
The Eclipse TensiTrak program generates three files for each drill run – one “*.ttd” project file and two
“*.oc2” files, one for the Force data and one for the Pressure data. All three files are required to be in the
same folder for the project data to display correctly.
NOTE: All project files (the *.ttd and two *.oc2 files) must be e-mailed and saved to the
same folder on the receiving computer so that the data will display correctly.
To e-mail files for a project, select the TensiTrak project “*.ttd” file and the two accompanying *.oc2 files
(for Force and Pressure) as attachments in your e-mailing application, and then send the e-mail. The
default location of the TensiTrak program data is C:\Program Files\Digital Control Incorporated\TensiTrak\
Data. You can see the different file types under the Data folder by setting the drop-down selection at the
bottom of the dialog box to “All Files (*.*)”, as shown below.
Open Dialog Box Showing “All Files”
NOTE: If you have made a PDF file of the project data, then you can select the PDF file for
e-mailing. The *.ttd and *.oc2 files are not required to view the PDF file.