User's Manual

Recording Data

24 Eclipse

TensiTrak

Operator’s Manual

1. Power Up TensiTrak Unit

Using Three C-Cell Alkaline Batteries

1. Inspect and clean as necessary the mud pressure sensor area, battery cap, and O-ring for

damage and wear.

2. Install three C-cell alkaline batteries into the battery compartment with the positive terminals first,

and then tighten the battery cap until it seats completely.

Loading Three C-cell Alkaline Batteries in TensiTrak Unit

Using SuperCell Lithium Battery

1. Inspect and clean as necessary the mud pressure sensor area, battery cap, and O-ring for

damage and wear.

2. Install the SuperCell lithium battery into the battery compartment with the positive terminals first,

followed by a spacer or dummy battery (positive terminal first), and then tighten the battery cap

until it seats completely.

Loading SuperCell Lithium Battery and Spacer in TensiTrak Unit

NOTE: You must use a spacer or a dummy battery behind the SuperCell battery to take up space

and provide the necessary ground connection.

Leading End (with

Battery Compartment)

Trailing End (with

Mud Pressure Sensor)

Install 3 C-cell

Alkaline Batteries

Leading End (with

Battery Compartment)

Trailing End (with

Mud Pressure Sensor)

Install SuperCell

Battery and Spacer

Space

SuperCell Battery