User's Manual
Table Of Contents
- This device complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference tha...
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Receiver
DigiTrak
®
F2
®
Operator’s Manual 27
Settings Menu
The settings menu allows you to change the depth units, pitch units, and transmitter options and to set a
roll offset, which is needed when the transmitter’s roll position must be compensated to match the drill
head’s roll position. When this menu option is selected, the following screen will appear with the depth
units option highlighted, as shown below.
Receiver Settings Menu
Click the trigger to toggle between options, and hold the trigger in when the desired option is highlighted.
Depth Units Menu
The depth units menu displays four options: 000" represents the use of inches only; 0'00" represents the
use of both feet and inches; 0.00M represents the use of metric units (meters and centimeters); and 0.00'
represents the use of feet only. An arrow points to the current setting, which is feet and inches in the
example shown below.
Depth Units Menu
Depth Units Menu
(Shown Highlighted)
Transmitter
Options Menu
Pitch Units Menu
Roll Offset Menu