User's Manual
Table Of Contents
- This device complies with Part 15 of the Rules of the FCC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference tha...
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Receiver
DigiTrak
®
F2
®
Operator’s Manual 17
Adjusting Screen Contrast
To make the screen lighter or darker, hold the trigger in with the
receiver held vertical and in locate mode (see photo). Release the
trigger when the screen contrast is adjusted to the desired level.
Main Menu
The main menu allows you to set the desired depth units, pitch units, roll offset, transmitter options, and
height-above-ground (HAG) distance; to select telemetry options; to calibrate the receiver to the trans-
mitter; to use the Target Steering function; and to turn off the receiver. To access the main menu, click
the trigger once from the locate mode screen. You will see six menu options, with the first one, the HAG
option, highlighted for selection.
Receiver Main Menu Screen
The main menu screen also displays the receiver battery status (in the top right corner), the transmitter
frequency setting (to the left of the battery status), and the current telemetry channel selection (channel 2
is shown in the example above). If the Target Steering menu has been programmed with a target depth,
you will see that number below the icon, as shown in the figure above. If the main menu is accessed by
accident, you can click through all the options to return to the locate mode screen or wait a few seconds
for the menu to time out and return to the locate mode screen.
To access a menu option, hold the trigger in with the option highlighted. The table below summarizes the
main menu options. Each option is described fully in the subsections following the table.
Receiver Battery Status
(Shown 80% Full)
Telemetry Channel Menu
(Channel 2 Selected)
Settings Menu
Target Steering Menu
Height-Above-Ground
(HAG) Menu
Power Off
Calibration Menu
Box around item
indicates it is high-
lighted for selection.
2'00"
Programmed Target Depth
Transmitter Frequency
Setting