User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- F Series Battery Charger System
- Receiver
- General Description
- Standard Receiver Display Screen Symbols
- /Power On
- Power Off
- Automatic Shutdown
- Toggle & Trigger Switches
- Audible Tones
- Main Menu
- /Calibration Menu
- /Height-Above-Ground (HAG) Menu
- /Settings Menu
- Transmitter Selection Menu
- /DigiTrak LWD (Log While Drilling) Menus
- Target Steering Menu
- Using the Keypad
- Display Screens
- Transmitter
- Remote Display
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Locating
68 DigiTrak
®
F5
®
Operator’s Manual
Receiver Locate Mode Screen
(Approaching LL)
Actual Position of
Receiver and Transmitter
NOTE: Do not rely on the alignment of the ball with the vertical crosshair to identify the left/right
position of the transmitter. The front and rear locate points must be accurately found to
determine the transmitter’s lateral position (heading) and to take accurate depth readings.
9. Position the receiver so that the LL aligns with the horizontal crosshair.
Receiver Locate Mode Screen
(at the LL)
Actual Position of
Receiver and Transmitter
RLP
FLP
LL
RLP
FLP
LL
Line-in-
the-box
Locate Line
(Red When
Not Aligned
in Box for
Depth
Reading)
Yaw
(Left/Right)
Rotation of
the Transmitter
Relative to
the Receiver)