User's Manual

Table Of Contents

Transmitter

44 DigiTrak

Operator’s Manual

Verify Signal

In order for the receiver to detect the signal from the transmitter, the receiver and transmitter must have

matching regional designation numbers as discussed earlier in this section and in the Receiver section.

The receiver must also be programmed to detect the frequency of the transmitter being used. The

frequency that the receiver is programmed to detect is displayed at the top of the menu screens.

To change the frequency the receiver is programmed to detect, you must select your transmitter type and

frequency from the Transmitter Selection menu in the receiver’s main menu. See the “Transmitter

Selection Menu” in the Receiver section and the table below for more information.

Transmitter Selection Menu Options

Menu Option Transmitter Model Frequency Clock Positions

5XD 19/12 19.2 kHz 24

5XD 19/12 12 kHz 24

5XD 12/1.3 Single Mode – 12 kHz 24

5XD 12/1.3 Dual Mode – 12 kHz 24

5XD 12/1.3 Dual Mode – 1.3 kHz 24

FX or FXL 12 kHz 12

FX 19 or FXL 19 19 kHz 12

5X 18.5 18.5 kHz 24

5X 8.4 8.4 kHz 24