User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- F Series Battery Charger System
- Receiver
- General Description
- Standard Receiver Display Screen Symbols
- /Power On
- Power Off
- Automatic Shutdown
- Toggle & Trigger Switches
- Audible Tones
- Main Menu
- /Calibration Menu
- /Height-Above-Ground (HAG) Menu
- /Settings Menu
- Transmitter Selection Menu
- /DigiTrak LWD (Log While Drilling) Menus
- Target Steering Menu
- Using the Keypad
- Display Screens
- Transmitter
- Remote Display
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- Appendix D: Reference Tables
- Appendix E: EU Required Documentation
- LIMITED WARRANTY
Receiver
DigiTrak
®
F5
®
Operator’s Manual 27
Set HAG
Selecting the set HAG option will open the keypad for setting an HAG value. The keypad will appear
slightly differently depending on the units the receiver is set to display. See “Using the Keypad” at the end
of this section for more information.
Decimal Keypad
Use the toggle switch to highlight the values you wish to set and pull the trigger after each selection to put
it in the display window. When the value in the display window matches the value you wish to set, select
the return arrow to lock in the value and turn on the function. You will be returned to the main menu with
HAG enabled.
Display
Window
Return Arrow
Exit
Backspace
Decimal Point
(will not show
with receiver in
inches mode)