Installation guide
8Installation Guide
GB
Read these safety instructions carefully before using the receiver. Heed all warnings and
notices on the device and in the user guide.
3.1 Basic safety instructions
Electrical connection
• Intheeventofoperatingmalfunctions,disconnectthereceiverfromthepowersource.
Note: Even when switched off at the mains switch on the back, the receiver is still
energized.
• Topreventtheriskoffireandelectricshock,donotexposethereceivertorainorany
other source of moisture.
• Neveropenthedevicecover.Otherwise,youruntheriskofelectricshock.
• Connect the receiver only to a professionally installed mains socket (220–240 V
~
,
50–60 Hz).
• Thetotalcurrentdrawatthe„LNBIN“antennaconnectiononthereceivermustnot
exceed 300 mA.
• Unplugthereceiverifunusedforextendedperiodsoftime.Tounplug,grasptheplug
only; do not pull on the cable.
• Unplugthereceiverduringlightningstorms.
• RemovetheLNBcablefromthereceiverduringlightningstorms.
• Ifliquidhasbeenspilledorobjectshavefallenintothereceiver,unplugthemainslead
immediately. Have the device servicedbyqualified service personnel beforeusingit
again. Otherwise, you run the risk of electric shock.
• Makesurethepowersource(mainssocket)iseasilyaccessible.
• Donotcompressorpinchthemainslead.
• If the mains lead is damaged, have the receiver serviced by qualified service
personnel before using it again. Otherwise, you run the risk of electric shock.
• Neverletchildrenusethereceiverunsupervisedorplaywiththeantennasystem.
• Refer all servicing to qualified service personnel. Otherwise, you place yourself and
others at risk.
• Intheeventofoperatingmalfunctions,disconnectthereceiverfromthepowersource.
• Obtainallreplacementpartsfromthemanufacturer.
• Ifanychangesaremadetothedevice,themanufacturerisabsolvedofallliability.
• Removeallprotectivefilm.
Warning!
Disconnection from the mains: Disconnection from the mains: The standby button on
this device does not fully disconnect the device from the mains. In standby mode, the
device continues to draw power. The only way to fully disconnect the device from the
mains is to unplug it from the wall socket.
3. SAFETY WARNING










